For best results, try to let a newly refilled cartridge sit for at least 1 day before installing it into your printer. The sponge needs this time to absorb the ink. You may wish to withdraw and re-insert the syringe at different angles in order to expose the whole sponge to the ink.ĥ) Wipe any excess ink off of the cartridge top and cover the hole with a piece of aluminum tape or electrical tape (press the tape down well to get a good seal), or seal with hot glue.Ħ) Let it sit for 45 minutes to 1 hour. inject the ink into the cartridge until the cartridge is full.
Try to get clear through the sponge to the bottom of the cartridge. The cartridge will hold about 15ml of ink.Ĥ) Insert the needle into the fill hole and push it well into the sponge. Seal this hole with the rivet provided.Ģ) Using the thumb drill, drill a small hole in the top right corner about 25 percent of the way from the right hand side of the cartridge top.ģ) Put the needle on to the syringe and draw up the ink. SSC Service Utility allow you to do many amazing things with Your Epson printer :ġ) Work directly with CSIC in Epson Stylus printers cartridges.Ģ) Reset or rewrite any chip using special addon device.Ĥ) Reset internal ink counters even with empty cartridges.ĥ) Separate cleaning of color and black heads for all Epson inkjet printers, powerful cleaning mode.ħ) Resetting of protection counter (even then it is already full).Ĩ) More then 100 different Epson printers supportedġ) Find the ink exit hole on the bottom of the cartridge. If not the SSC utility does not make sense too Perhaps the refill pack is cheaper than the compatible ink cartridge. Because the ink low level and I don’t have refill pack! But at last, I still buy another cartridge to replace. It work for me too, I reseted all counters (protection counter, ink counter). Follow the instruction to configure your Epson printer model then reset the counters to zero.
Download SSCServe v4.30 and install took me few seconds. What I need is SSC Service Utility for Epson Stylus printer.
Send to Epson service center to reset or do it myself to save some money. Nowander my cartridge still has ink but can’t print. It end print when reach the limit even still got ink. Well, it may due to “internal ink counter” or “protection counter” full.Įpson put smart chip into cartridge. Many users have same problem with Epson and post for help in forums. Why it does not move at all even test print? After take out cartridge, found the ink is still available. After print few hundreds of sheets, it just don’t print at all. I bought a Epson compatible ink cartridge few days ago. Have you experienced printer cannot print even with newly bought ink cartridge ?